Helpdesk

After four or five attempts to flash a new firmware with the new GUI, apparently the flashing had succeeded and I hit shutdown within the same interface. Have earlier configured to use mUSB as main . source and battery-pack as secondary. Tried to restart by reattaching the mUSB, leading to steady blue LED light but no rebooted Pi. Pulled the jumper Cap a couple of times, to no avail.


Please advise,


Murr

mirrormurr

24.07.21 23:22

Hello mirrormurr,


did you put the Flash-jumper back into its "off"-position?


[nbsp]

27.07.21 12:35

Dear Niklas,


Must admit I got a little confused there for a minute, truly sometimes the solutions are there right in the open..


But, alas, I had moved the flash-jumper back to off before restarting. I guess we will have to continue troubleshooting...


Murr

mirrormurr

28.07.21 09:07

Hello mirrormurr,


maybe reflashing the firmware again could fix the problem.


Otherwise we would recommend getting a replacement for your StromPi.


Yours sincerely,


Niklas Tritschler

28.07.21 10:46

I'll attempt to re-flash.


Do you recommend using the new UI (on top of this form) or use terminal?


M

mirrormurr

28.07.21 23:31

Ofcourse you can use the StromPi3 configurator made by Gismo. Maybe it is worth a try.


Yours sincerely,


Niklas Tritschler

29.07.21 12:33