Helpdesk

I think it is great that you are updating the firmware all the time and am happy to see the improvements. One update that I would really like to see is to be able to set the strompi parameters via a python script instead of using the 'sudo screen /dev/serial0 38400 command'. As it is now possible with the new firmware to get the strompi status, perhaps this is not too difficult to add? A simple script could have functions like: wakeup_alarm(mode = "Time-Alarm", time = "00:00", status = "Enabled") etc. Would that be possible?

Hi joljols,
we just released a config script for the StromPi 3. You can get it here or in our Downloads section.


Best regards.
Nils

Wonderful! So the script should be run in terminal via python strompi_config.py right? I will give it a try later today.
Many thanks for the fast work on this!

Hi joljols,
yes, that's correct. But be aware that this script is written for Python 3. Start it with:
python3 ./strompi_config.py
Best regards.
Nils